2024– date –

Install the cover that was removed in the maintenance record ‘How to remove fuel tank cover’. When removing and installing the cover, it catches on the fuel tank and is pushed to the left and right.So, I wondered if I could reduce this b...

After some work, I repeated the removal and installation of the fuel tank cover, and I will summarize how I did it and what I noticed. Actually, it was more difficult than I imagined removing it, and in the end, I had to do it by force.I...

This is a continuation of the maintenance record ‘Replace tail tidy 3 【Assembly】’. The temporarily assembled tail tidy (R&G's LP0162BK) is installed on moto's body.I thought I had the wiring together and all I needed to do was inst...

This is a continuation of the maintenance record ‘Replate tail tidy2【preparation】’. Finally, the tail tidy (R&G LP0162BK) is assembled. When installing the tail tidy, there is a point that we want to pay attention to so that it doe...

This is a continuation of the maintenance record 'Replace tail tidy 1【Removal】'. The tail tidy to be fitted is the R&G LP0162BK.This is not a bolt-on kit and the following must be prepared. Wiring modifications to the license plate...

At the time of purchase, the moto came with a one-off tail tidy fitted by the previous owner.This also included LED number lights and reflectors, which worked perfectly, but had the following problems. Number plate is improperly fitted. ...

1. Used to prevent rust. As I mentioned "Maintenance record", rust on the front fork inner tube can be a hassle.If the plating is broken even a little, the only thing you can do is slow down the progress. (Except for re-plating.) I chose...

1. To prevent scratches on the upper side cowl. The R125 (5D7) has a bracket on the outside of the upper side cowl to hold the side cover in place.This bracket is a problem, and when removing and installing the upper side cowl, I bump it...

1. There are a few tips for installation as well. Here are some notes on installation that I have not noticed when removing it. If you have any of the following concerns about fitting rear cowls and panel etc., here are a few tips for yo...

I never ride with two people.So, I decided to remove the passenger brackets and steps, which I never use. Removing the passenger brackets simplifies the area around the rear cowl and accentuates the sharpness of the R125.On the other han...