Installation / replacement– category –

After some work, I repeated the removal and installation of the fuel tank, and I will summarize how I did it and what I noticed. Removing the fuel tank, Cleaning and replacing the air cleaner filter Cleaning the throttle body Replacing t...

＜Fuel tank cover＞ When I removed the fuel tank cover previously, I noticed the following two things. The drain hose grommet leading to the petrol filling port is not the right size The cap on the cap nut that holds the fuel tank cover ...

Tapping screws used to fix the cowl, panels, etc. on the R125.This part is sometimes broken… When tightening, if it starts spinning and cannot be tightened firmly, it is an indication that the spring nut / 90183-05X03 on the female threa...

The following are notes on the installation of the front cowl/panel. You have removed the front cowl and panels etc., but when you try to install it, I don't feel confident about the work. I forgot where to fix the wires. Here is an over...

Put back the front stay that were removed in the maintenance record ‘How to remove front stay’. Once the front stays are removed, the mounting position of the front stays changes slightly, The position of the front panel and frame will n...

After the maintenance record ‘How to remove the front cowl and panels etc.’, the front stay (including the meter) was also removed.So, this section summarizes how to remove them. Removing the front stay makes it easier to carry out the f...

Following the side and rear, this section summaries the maintenance record ‘How to remove and install front cowl and panels etc.’. If the front cowl panel can be removed, the range of customization and maintenance can be expanded.For exa...

Install the cover that was removed in the maintenance record ‘How to remove fuel tank cover’. When removing and installing the cover, it catches on the fuel tank and is pushed to the left and right.So, I wondered if I could reduce this b...

After some work, I repeated the removal and installation of the fuel tank cover, and I will summarize how I did it and what I noticed. Actually, it was more difficult than I imagined removing it, and in the end, I had to do it by force.I...

This is a continuation of the maintenance record ‘Replace tail tidy 3 【Assembly】’. The temporarily assembled tail tidy (R&G's LP0162BK) is installed on moto's body.I thought I had the wiring together and all I needed to do was inst...