2025– date –

The high beam is the left-side headlight in the direction of travel, and the bulb type is H7.Unlike the low beam, the socket is fixed directly to the headlight unit. Once you know how to remove the bulb, you can do the following tasks: R...

This guide explains how to remove and install the low beam bulb.The low beam is the headlight on the right side when facing forward, and the bulb type is H7. Once you know how to remove the bulb, you’ll be able to: Replace a burnt-out bu...

This guide explains how to remove and reinstall the headlight unit from the front cowl—specifically for the right-side headlight. You may not often need to remove the headlight unit, but it becomes necessary in the following cases: Repla...

This is a continuation of "Motorcycle Dash Cam Installation 8 – Installing the Switch".In this final ninth installment, I' ll verify the operation of the installed dashcam and adjust the camera positions. The drive recorder used is the M...

This is a continuation of "Motorcycle Dash Cam Installation 7 – Installing the Front Camera".In this eighth installment, I’ll be installing the switch. The drive recorder used is the Mitsuba Sankowa / EDR-21A.I’ll mount the custom-made b...

This is a continuation of "Motorcycle Dash Cam Installation 6 – Installing the Rear Camera".In this seventh installment, I’ll walk through the process of installing the front camera. The drive recorder used is the Mitsuba Sankowa / EDR-2...

This is a continuation of "Motorcycle Dash Cam Installation 5 – Installing the Main Unit".In this sixth installment, we’ll be installing the rear camera. The drive recorder used is the Mitsuba Sankowa / EDR-21A.Since the fender has been ...

Now that I've prepared the necessary brackets, it's time to mount the drive recorder onto the bike.The model I'm using is the Mitsuba Sankowa EDR-21A. The mounting positions of each component and the wiring layout, as determined in the m...

This fourth installment covers the fabrication of a bracket for the drive recorder switch.To mount it in the location decided in the maintenance record “Motorcycle Dash Cam Installation 1 – Planning the Setup”, I focused on the following...

In this third installment, I'll be fabricating brackets for the dashcam cameras. To mount them at the locations decided in the maintenance record "Motorcycle Dash Cam Installation Part 1 - Planning the Setup", the brackets will be design...