(Green)^2– Author –

This section summarizes the ceramic coating of front stay and meter unit. In recent years, the sun's rays have been so strong that plastic parts are getting sunburned.The front stay, which occupy a large area around the front of the moto...

I will summarize how to remove and install the meter unit. From the beginning, but I broke the threaded part when installing the meter unit.I will tell you at the beginning that there is a risk of breaking by removing and installing. By ...

In this fourth installment, I will install and connect the wiring prepared in the maintenance record “Install burglar Alarm3【Processing wiring】” to the moto body.In order to install the device and wiring inside the frame and cowl, I wi...

In this third installment, I will modify the wiring for the burglar alarm.The wiring for each wire is processed to the length determined in the maintenance record “Install burglar Alarms 1【Consider installation method】”. Although it ta...

In this second installment, I will fabricate a bracket for the main body of the burglar alarm.The bracket is placed across the engine control unit, and the main body is placed on top of it. Making the bracket is a bit time-consuming, but...

I have always wanted to protect my moto from mischief and theft, so I was interested in a security device.I looked on the Internet and learned that there was a theft alarm (Protec/CS-550M) that could be retrofitted, and I thought this wo...

I bought a retrofit burglar alarm and a drive recorder.Both require an electrical signal from the ignition switch OFF (ON), so the ignition power supply (hereinafter described as IG power supply) is taken out from the moto body. The foll...

Following the rear, the front brake fluid is replaced.This will be the first time to replace the fluid as well, two and a half years after the moto was delivered. There are three main methods of replacing brake fluid as described below, ...

This is a continuation of the maintenance record “Check and clean front brake 1 【Removal and clean】”. Now that the parts have been cleaned, put them back together.To ensure smooth movement of the brake pistons and brake pads, properly ...

Since the rear brakes were checked and cleaned, the front brake calipers should also be done, and the condition and thickness of the brake pads should be checked along with them. From this article you will learn the following. How to rem...