(Green)^2– Author –

This is a continuation of the maintenance record “Replace to LED turn signals 2 【Assemble and install front turn signals】”. In this third installment, I will assemble and install the rear turn signals. Since I prepared a similar after-...

This is a continuation of the maintenance record “Replacement to LED turn signals1 【Replace to turn signal relay for LED】”. In this second installment, I will assemble and install the front turn signals. Most LED turn signals on the ma...

Although recent motorcycles are increasingly using LEDs for lights, the R125 (5D7)'s factory turn signals are bulbs (LEDs are optional).Perhaps because the 125cc model is an entry grade, it is difficult to spend money on details. Knowing...

Following the instructions for removing and installing the front turn signals, I will now summarize how to remove and install the rear turn signals. The turn signals on my moto are mounted to R&G's tail tidy / LP0162BK. It is not a g...

The turn signals on R125 (5D7) seems to break off at the base over time.If you look at motos listed on Yahoo! Auctions, you will sometimes see turn signals listed with broken. In order to repair or replace a broken turn signal, it must b...

＜Fuel tank cover＞ When I removed the fuel tank cover previously, I noticed the following two things. The drain hose grommet leading to the petrol filling port is not the right size The cap on the cap nut that holds the fuel tank cover ...

Tapping screws used to fix the cowl, panels, etc. on the R125.This part is sometimes broken… When tightening, if it starts spinning and cannot be tightened firmly, it is an indication that the spring nut / 90183-05X03 on the female threa...

The following are notes on the installation of the front cowl/panel. You have removed the front cowl and panels etc., but when you try to install it, I don't feel confident about the work. I forgot where to fix the wires. Here is an over...

Put back the front stay that were removed in the maintenance record ‘How to remove front stay’. Once the front stays are removed, the mounting position of the front stays changes slightly, The position of the front panel and frame will n...

After the maintenance record ‘How to remove the front cowl and panels etc.’, the front stay (including the meter) was also removed.So, this section summarizes how to remove them. Removing the front stay makes it easier to carry out the f...