(Green)^2– Author –

This is a continuation of the maintenance record ‘Replate tail tidy2【preparation】’. Finally, the tail tidy (R&G LP0162BK) is assembled. When installing the tail tidy, there is a point that we want to pay attention to so that it doe...

This is a continuation of the maintenance record 'Replace tail tidy 1【Removal】'. The tail tidy to be fitted is the R&G LP0162BK.This is not a bolt-on kit and the following must be prepared. Wiring modifications to the license plate...

At the time of purchase, the moto came with a one-off tail tidy fitted by the previous owner.This also included LED number lights and reflectors, which worked perfectly, but had the following problems. Number plate is improperly fitted. ...

1. Used to prevent rust. As I mentioned "Maintenance record", rust on the front fork inner tube can be a hassle.If the plating is broken even a little, the only thing you can do is slow down the progress. (Except for re-plating.) I chose...

1. To prevent scratches on the upper side cowl. The R125 (5D7) has a bracket on the outside of the upper side cowl to hold the side cover in place.This bracket is a problem, and when removing and installing the upper side cowl, I bump it...

1. There are a few tips for installation as well. Here are some notes on installation that I have not noticed when removing it. If you have any of the following concerns about fitting rear cowls and panel etc., here are a few tips for yo...

I never ride with two people.So, I decided to remove the passenger brackets and steps, which I never use. Removing the passenger brackets simplifies the area around the rear cowl and accentuates the sharpness of the R125.On the other han...

1.Mudguard has holes in it I noticed this when I removed the mudguard (black plastic part on the underside of the rear cowl) in the maintenance records ‘How to remove rear cowls and panel etc.’. To my surprise, there are three holes in t...

1. To keep track of where parts have been removed and to prevent loss The R125 has a large number of cowls and panels, so many bolts, screws etc. are used to fix them in place.The number is, When side panels and cowls are removed: 37 Whe...

1. For removing push rivets Push rivets are used to secure the lower side cowl, mudguard and other parts of the YZF-R125 (5D7W).These can be removed by using this dowel pin punch to push in the middle pin of the push rivet. ＜Removing an...