Maintenance records– category –

1. Remove the fuel tank cover. After some work, I repeated the removal and installation of the fuel tank cover, and I will summarize how I did it and what I noticed. Actually, it was more difficult than I imagined removing it, and in the...

1. Install tail tidy to moto This is a continuation of the maintenance record ‘Replace tail tidy 3 【Assembly】’. The temporarily assembled tail tidy (R&G's LP0162BK) is installed on moto's body.I thought I had the wiring together an...

1. Install components in the tail tidy This is a continuation of the maintenance record ‘Replate tail tidy2【preparation】’. Finally, the tail tidy (R&G LP0162BK) is assembled. When installing the tail tidy, there is a point that we ...

1. Prepare tail tidy before assembly. This is a continuation of the maintenance record 'Replace tail tidy 1【Removal】'. The tail tidy to be fitted is the R&G LP0162BK.This is not a bolt-on kit and the following must be prepared. Wir...

1. Replace tail tidy At the time of purchase, the moto came with a one-off tail tidy fitted by the previous owner.This also included LED number lights and reflectors, which worked perfectly, but had the following problems. Number plate i...

1. There are a few tips for installation as well. Here are some notes on installation that I have not noticed when removing it. If you have any of the following concerns about fitting rear cowls and panel etc., here are a few tips for yo...

1. Remove passenger brackets I never ride with two people.So, I decided to remove the passenger brackets and steps, which I never use. Removing the passenger brackets simplifies the area around the rear cowl and accentuates the sharpness...

1.Mudguard has holes in it I noticed this when I removed the mudguard (black plastic part on the underside of the rear cowl) in the maintenance records ‘How to remove rear cowls and panel etc.’. To my surprise, there are three holes in t...

1.Remove parts and apply ceramic coating A ceramic coating is a great way to keep your moto looking as good as possible for as long as possible.A ceramic coating will Longer-lasting gloss. dirt is easier to remove. So, cleaning afterward...

1. I'll also remove the rear cowls and panel. Following the maintenance record ‘How to remove and install side cowls, panels, etc.’, this section summarizes ‘How to remove and install rear cowls, panel, etc.’. There may be few opportunit...