Exterior– category –

This guide summarizes how to remove and install position bulbs.At the same time, I’ll replace them with LED position bulbs that I prepared in the maintenance record “LED Position Light Bulb Kit Assembly.” The position light bulbs are loc...

Instead of simply swapping a halogen bulb for a store-bought LED bulb, this guide explains how to assemble an LED bulb yourself.The R125 uses two position bulbs, and the bulb type is T10. Benefits of assembling your own LED bulb: You can...

The high beam is the left-side headlight in the direction of travel, and the bulb type is H7.Unlike the low beam, the socket is fixed directly to the headlight unit. Once you know how to remove the bulb, you can do the following tasks: R...

This guide explains how to remove and install the low beam bulb.The low beam is the headlight on the right side when facing forward, and the bulb type is H7. Once you know how to remove the bulb, you’ll be able to: Replace a burnt-out bu...

This guide explains how to remove and reinstall the headlight unit from the front cowl—specifically for the right-side headlight. You may not often need to remove the headlight unit, but it becomes necessary in the following cases: Repla...

After some work, I repeated the removal and installation of the fuel tank, and I will summarize how I did it and what I noticed. Removing the fuel tank, Cleaning and replacing the air cleaner filter Cleaning the throttle body Replacing t...

When I was taking the moto out of the parking lot, I hit the front right side turn signal and broke it.Since I have thought about the repair method and prepared the parts, as described in the maintenance record “Repair turn signal1 【Con...

When I was taking my moto out of the parking lot, I unexpectedly hit my front right blinker and broke it.I would like to replace the whole blinker, but due to the cost, I decided to repair it.I found on the Internet that there are variou...

The SAVAGE LED turn signals I replaced were in stock form and had smoked lenses.I wanted to make them “look like stock but somehow LED”. So, I will try to see if I can put the stock clear lenses on them. The reasons for replacing the len...

Since the rear turn signals have been replaced with LEDs, this is an opportunity to review the wiring for the license plate lights with regard to the following. Make the wiring the proper length to fit the tail tidy. Use the connector of...