Lights / lamps– category –

When I was taking the moto out of the parking lot, I hit the front right side turn signal and broke it.Since I have thought about the repair method and prepared the parts, as described in the maintenance record “Repair turn signal1 【Con...

When I was taking my moto out of the parking lot, I unexpectedly hit my front right blinker and broke it.I would like to replace the whole blinker, but due to the cost, I decided to repair it.I found on the Internet that there are variou...

The SAVAGE LED turn signals I replaced were in stock form and had smoked lenses.I wanted to make them “look like stock but somehow LED”. So, I will try to see if I can put the stock clear lenses on them. The reasons for replacing the len...

Since the rear turn signals have been replaced with LEDs, this is an opportunity to review the wiring for the license plate lights with regard to the following. Make the wiring the proper length to fit the tail tidy. Use the connector of...

This is a continuation of the maintenance record “Replace to LED turn signals 2 【Assemble and install front turn signals】”. In this third installment, I will assemble and install the rear turn signals. Since I prepared a similar after-...

This is a continuation of the maintenance record “Replacement to LED turn signals1 【Replace to turn signal relay for LED】”. In this second installment, I will assemble and install the front turn signals. Most LED turn signals on the ma...

Following the instructions for removing and installing the front turn signals, I will now summarize how to remove and install the rear turn signals. The turn signals on my moto are mounted to R&G's tail tidy / LP0162BK. It is not a g...

The turn signals on R125 (5D7) seems to break off at the base over time.If you look at motos listed on Yahoo! Auctions, you will sometimes see turn signals listed with broken. In order to repair or replace a broken turn signal, it must b...