Exterior– category –

1. Remove steps and pedals for cleaning When I was hanging up the bike cover, I suddenly found it on the steps and pedals area."There's quite a bit of grease on them…" If I put the bike cover on like this, the inside of the cover is goin...

1. Some small precautions for installation Here is a list of things to look out for when installing that I may not have noticed when removing.Have you experienced any of the following when fitting? Though I tried to fit side cowls/panels...

The number of cowls and panels on the YZF-R125 (5D7W)- five on each side and ten on the left and right sides - is outstandingly large compared to other motos.(Not including the front and rear cowls and front and rear panels.) ＜Cowl - Pa...

When I set a rear paddock stand with a J-trip L-fixture on my YZF-R125 (5D7W), I noticed the following. When loosening/tightening the axle shaft, the socket hits the L-fixture, and it is difficult to loosen/tighten the nut. The vehicle l...

To rear paddock stand bobbins (hereafter described as the bobbins) to the YZF-R125 (5D7W), a threaded hole must be machined on the swingarm. The screw size for the bobbins used by Yamaha is M6 with a pitch of 1.0.These threaded holes are...

The YZF-R125 is a true super sport, with a forward leaning position.After riding for a long time, your hands, feet, back, etc. will become tired and sore.To reduce such fatigue and pain as much as possible, it is important to adjust the ...