Maintenance records– category –
-
Replace turn signal lens
The SAVAGE LED turn signals I replaced were in stock form and had smoked lenses.I wanted to make them “look like stock but somehow LED”. So, I will try to see if I can put the stock clear lenses on them. The reasons for replacing the len... -
Wiring modification of license plate light
Since the rear turn signals have been replaced with LEDs, this is an opportunity to review the wiring for the license plate lights with regard to the following. Make the wiring the proper length to fit the tail tidy. Use the connector of... -
Replace to LED turn signals3【Assemble and install rear turn signals】
This is a continuation of the maintenance record “Replace to LED turn signals 2 【Assemble and install front turn signals】”. In this third installment, I will assemble and install the rear turn signals. Since I prepared a similar after-... -
Replace to LED turn signals2【Assemble and install front turn signals】
This is a continuation of the maintenance record “Replacement to LED turn signals1 【Replace to turn signal relay for LED】”. In this second installment, I will assemble and install the front turn signals. Most LED turn signals on the ma... -
Replace to LED turn signals1【Replace to turn signal relay for LED】
Although recent motorcycles are increasingly using LEDs for lights, the R125 (5D7)'s factory turn signals are bulbs (LEDs are optional).Perhaps because the 125cc model is an entry grade, it is difficult to spend money on details. Knowing... -
How to remove and install rear turn signals
Following the instructions for removing and installing the front turn signals, I will now summarize how to remove and install the rear turn signals. The turn signals on my moto are mounted to R&G's tail tidy / LP0162BK. It is not a g... -
How to remove and install front turn signals
The turn signals on R125 (5D7) seems to break off at the base over time.If you look at motos listed on Yahoo! Auctions, you will sometimes see turn signals listed with broken. In order to repair or replace a broken turn signal, it must b... -
Replace grommet and cap around fuel tank
＜Fuel tank cover＞ When I removed the fuel tank cover previously, I noticed the following two things. The drain hose grommet leading to the petrol filling port is not the right size The cap on the cap nut that holds the fuel tank cover ... -
Replace spring nuts for cowls
Tapping screws used to fix the cowl, panels, etc. on the R125.This part is sometimes broken… When tightening, if it starts spinning and cannot be tightened firmly, it is an indication that the spring nut / 90183-05X03 on the female threa... -
How to install front cowl and panels etc.
The following are notes on the installation of the front cowl/panel. You have removed the front cowl and panels etc., but when you try to install it, I don't feel confident about the work. I forgot where to fix the wires. Here is an over...
