Maintenance records– category –

This is a continuation of the maintenance record 'Replace tail tidy 1【Removal】'. The tail tidy to be fitted is the R&G LP0162BK.This is not a bolt-on kit and the following must be prepared. Wiring modifications to the license plate...

At the time of purchase, the moto came with a one-off tail tidy fitted by the previous owner.This also included LED number lights and reflectors, which worked perfectly, but had the following problems. Number plate is improperly fitted. ...

1. There are a few tips for installation as well. Here are some notes on installation that I have not noticed when removing it. If you have any of the following concerns about fitting rear cowls and panel etc., here are a few tips for yo...

I never ride with two people.So, I decided to remove the passenger brackets and steps, which I never use. Removing the passenger brackets simplifies the area around the rear cowl and accentuates the sharpness of the R125.On the other han...

1.Mudguard has holes in it I noticed this when I removed the mudguard (black plastic part on the underside of the rear cowl) in the maintenance records ‘How to remove rear cowls and panel etc.’. To my surprise, there are three holes in t...

1.Remove parts and apply ceramic coating A ceramic coating is a great way to keep your moto looking as good as possible for as long as possible.A ceramic coating will Longer-lasting gloss. dirt is easier to remove. So, cleaning afterward...

Following the maintenance record ‘How to remove and install side cowls, panels, etc.’, this section summarizes ‘How to remove and install rear cowls, panel, etc.’. If you could remove the rear cowl panel, it can be useful when carrying o...

Rust on front fork inner tubes is a nuisance.Once the plating has been broken, even slightly, the only thing left to do is to deal with it and slow its progress. (Except for re-plating.) In the maintenance record ‘Inspection of delivered...

1. Check drive sprocket wear In the maintenance record 'Inspection of delivered moto' I checked the driven sprocket, but I have not yet checked the drive sprocket.So, this time, at the same time as the maintenance record ‘How to remove s...

1. Install cleaned steps and pedals This is a continuation of the maintenance record "Check and Clean steps and pedals". A torque wrench is used extensively around the step and pedal area, as tightening torques are specified.The tighteni...