What a good-looking moto you are!

Put back the front stay that were removed in the maintenance record ‘How to remove front stay’. Once the front stays are removed, the mounting position of the front stays changes slightly, The position of the front panel and frame will n...

After the maintenance record ‘How to remove the front cowl and panels etc.’, the front stay (including the meter) was also removed.So, this section summarizes how to remove them. Removing the front stay makes it easier to carry out the f...

Following the side and rear, this section summaries the maintenance record ‘How to remove and install front cowl and panels etc.’. If the front cowl panel can be removed, the range of customization and maintenance can be expanded.For exa...

Install the cover that was removed in the maintenance record ‘How to remove fuel tank cover’. When removing and installing the cover, it catches on the fuel tank and is pushed to the left and right.So, I wondered if I could reduce this b...

After some work, I repeated the removal and installation of the fuel tank cover, and I will summarize how I did it and what I noticed. Actually, it was more difficult than I imagined removing it, and in the end, I had to do it by force.I...

This is a continuation of the maintenance record ‘Replace tail tidy 3 【Assembly】’. The temporarily assembled tail tidy (R&G's LP0162BK) is installed on moto's body.I thought I had the wiring together and all I needed to do was inst...

This is a continuation of the maintenance record ‘Replate tail tidy2【preparation】’. Finally, the tail tidy (R&G LP0162BK) is assembled. When installing the tail tidy, there is a point that we want to pay attention to so that it doe...

This is a continuation of the maintenance record 'Replace tail tidy 1【Removal】'. The tail tidy to be fitted is the R&G LP0162BK.This is not a bolt-on kit and the following must be prepared. Wiring modifications to the license plate...

At the time of purchase, the moto came with a one-off tail tidy fitted by the previous owner.This also included LED number lights and reflectors, which worked perfectly, but had the following problems. Number plate is improperly fitted. ...

1. Used to prevent rust. As I mentioned "Maintenance record", rust on the front fork inner tube can be a hassle.If the plating is broken even a little, the only thing you can do is slow down the progress. (Except for re-plating.) I chose...