What a good-looking moto you are!

Rust on front fork inner tubes is a nuisance.Once the plating has been broken, even slightly, the only thing left to do is to deal with it and slow its progress. (Except for re-plating.) In the maintenance record ‘Inspection of delivered...

1. Background of arrangements When removing the lower side cowl tapping screw, I noticed that if I used my short hexagon bit socket, it would hit the lower side cowl.So, I bought this long hexagon bit socket to avoid damaging the cowl. Y...

1. Suitable for exterior removal and installation A 4 mm hexagonal spanner is often used to remove and install the exterior of the YZF-R125 (5D7).Of course, you can work with on-board tools, but for efficiency you will want a hexagon soc...

1. Check drive sprocket wear In the maintenance record 'Inspection of delivered moto' I checked the driven sprocket, but I have not yet checked the drive sprocket.So, this time, at the same time as the maintenance record ‘How to remove s...

1. Install cleaned steps and pedals This is a continuation of the maintenance record "Check and Clean steps and pedals". A torque wrench is used extensively around the step and pedal area, as tightening torques are specified.The tighteni...

1. Remove parts for checking and cleaning This is a continuation of the maintenance record "How to remove steps and pedals". If you are riding your R125 and see any of the following signs, I recommend that you have your step pedals check...

1. Remove steps and pedals for cleaning When I was hanging up the bike cover, I suddenly found it on the steps and pedals area."There's quite a bit of grease on them…" If I put the bike cover on like this, the inside of the cover is goin...

In the maintenance record "Inspection of delivered moto" STEP 3-8, it was noticed that engine oil was leaking from the drain bolt area. ＜Engine oil leakage＞ Oil was also dripping onto the muffler and under cowl and was quite oily. I wi...

1. Some small precautions for installation Here is a list of things to look out for when installing that I may not have noticed when removing.Have you experienced any of the following when fitting? Though I tried to fit side cowls/panels...

1. Coating with parts removed. Ceramic coating is a great way to keep your car looking as good as possible for as long as possible.Ceramic coating makes subsequent cleaning easier for the following reasons. Long-lasting gloss Easy to cle...