What a good-looking moto you are!

Following the maintenance record ‘How to remove and install side cowls, panels, etc.’, this section summarizes ‘How to remove and install rear cowls, panel, etc.’. If you could remove the rear cowl panel, it can be useful when carrying o...

1. To prevent over-tightening The spring nut, which is used extensively on the YZF-R125 (5D7), will break if the tapping screw is over-tightened.So, I now use this quick spinner / BE3-Q and handle / AB-53 as much as possible to prevent o...

1. To prevent over-tightening Up to now, I have been using a combination of a KTC sliding head handle + extension bar like a T-type hexagonal spanner to remove and install the bolts and tapping screws that hold the cowl in place.However,...

Rust on front fork inner tubes is a nuisance.Once the plating has been broken, even slightly, the only thing left to do is to deal with it and slow its progress. (Except for re-plating.) In the maintenance record ‘Inspection of delivered...

1. Background of arrangements When removing the lower side cowl tapping screw, I noticed that if I used my short hexagon bit socket, it would hit the lower side cowl.So, I bought this long hexagon bit socket to avoid damaging the cowl. Y...

1. Suitable for exterior removal and installation A 4 mm hexagonal spanner is often used to remove and install the exterior of the YZF-R125 (5D7).Of course, you can work with on-board tools, but for efficiency you will want a hexagon soc...

1. Check drive sprocket wear In the maintenance record 'Inspection of delivered moto' I checked the driven sprocket, but I have not yet checked the drive sprocket.So, this time, at the same time as the maintenance record ‘How to remove s...

1. Install cleaned steps and pedals This is a continuation of the maintenance record "Check and Clean steps and pedals". A torque wrench is used extensively around the step and pedal area, as tightening torques are specified.The tighteni...

1. Remove parts for checking and cleaning This is a continuation of the maintenance record "How to remove steps and pedals". If you are riding your R125 and see any of the following signs, I recommend that you have your step pedals check...

1. Remove steps and pedals for cleaning When I was hanging up the bike cover, I suddenly found it on the steps and pedals area."There's quite a bit of grease on them…" If I put the bike cover on like this, the inside of the cover is goin...